BendPak 6P Installation Question

[DMEX]

Perhaps someone here can give me some advice on the installation of the Hydraulic Lines on my BendPak 6P Lift?

I have not poured the concrete floor yet and I wish to install PVC Tubes in the ground and run the Lines through them. What I need is information on where to bury the Tubes so I can keep the Lines out-of-sight from the Lift to the wall where the Power Unit will be mounted.

Figure 7 on Page 15 of the Installation Manual has to measurements.

 

[e-tek]

Do you mean the p-6 pit lift?

If so, there's an AWESOMe thread someone will be able to find that shows the entire install done to perfection. As I recall, he pounded some metal tubes though the sand/dirt under your concrete from one pad to the other, then from there to the controller, then ran hislines through those.

Take lots pics!

 

[DMEX]

Thank you for answering so quickly. I did a quick search before but found nothing. Maybe the wording was wrong. I'll try again.

 

[e-tek]

Here ya go - you're gonna LOVE it!

http://www.garagejournal.com/forum/showthread.php?t=35433&highlight=in-floor+lift+install

 

[DMEX]

Hey! Thanks.