Bendpak HD-9ST owners – need dimensions

[WhoWhatNow]

I’m looking for an owner of a Bendpak HD-9ST (the narrow width version) to confirm the overall length and width dimensions. I know what the spec sheet says, but I would like to have a real word confirmation before ordering. I have a very small space to put this in and every inch counts. Could owners measure from the outside of the base plates in each dimension. The outside L X W should be 174” X 100.25”. Thanks in advance.

 

[WhoWhatNow]

Bump for the evening crowd.

 

[WhoWhatNow]

Crickets.....

 

[WhoWhatNow]

one last time...

 

[SMKN LS1]

174” x 100-3/8” on mine. Built in 2012.

 

[SMKN LS1]

and the motor/reservoir extends off one tower by an additional 8”-9” on the 174” side. It’s obviously higher than the base plate...

 

[WhoWhatNow]

174” x 100-3/8” on mine. Built in 2012.

and the motor/reservoir extends off one tower by an additional 8”-9” on the 174” side. It’s obviously higher than the base plate...

Thank you!

Now I just need to figure out what to do about a bridge jack and place the order.