bendpak micro switch

[deprice]

Bendpak 10a 2 post lift wiring the micro switch for top. Do I pig tail or splice into the wires on the power motor on start and stop switch.Bendpak supplied a 4 wire wire for this.Thanks pictureswould be great

 

[pattenp]

Don't the instructions show how to wire it? You should not have to be doing any splicing. The switch should just connect in line on one of the power legs. I assume you have a 240V power unit.

 

[deprice]

Directions are ****, it is 240

 

[Stuart in MN]

Here is the schematic from the installation manual, at http://www.bendpak.com/XPR-7A-10-10A-168-Manual-REV-E-02-11-15-WEB.pdf