Marcos45/70
Active member
My trusty old bench grinder finally started acting up. Obvious balance problem, capacitor and one bearing started to go. Anyway, as I'm pulling it apart my BIL shows up. This guy can and will over talk any activities going on around him. I had done pretty good marking and taking note of part placement. Before he had came I stamped the bearing caps right and left and remembered the spring washer that fits between bearing and cap. I remember pulling all of these brass washers off together. I just don't remember which side. I can't find any parts breakdown and most threads seem to skip the bearing arrangement. Does anyone know where these washers go or have some diagram? Any help is appreciated.
I'm sorry guys, I have tried and tried to get the pics right side up but the iPad does what it wants every single time when I try to post pics. It is very frustrating.
I'm sorry guys, I have tried and tried to get the pics right side up but the iPad does what it wants every single time when I try to post pics. It is very frustrating.
