Boom arm for Elec cord reel.

[Thumper68]

I have a cord reel hanging somewhat above the fab table and while it worked okay I decided that it would be better if it had a bit of adjustablity and range.

After a bit of pondering and staring at the current location and materials on hand I came up with this.

Nice short 6:30 video of the build and function.

Hope you enjoy.

 

[FadedGray]

Simple enough. Nice job.

 

[larry4406]

I like this!

What cold cut saw is that?

On your fab table, I assume your welder's ground clamp is connected to a stud on the table?

 

[Thumper68]

Simple enough. Nice job.

Thanks, I like simple for projects like that, and I used up some off cuts I had on hand.

I like this!

What cold cut saw is that?

On your fab table, I assume your welder's ground clamp is connected to a stud on the table?

That one is the Jepson Super dry cutter, a bit on the pricey side but well worth it to me.

Yes there are several studs on the bottom of the table to attach the work lead too.