Bought a Lista + Vidmar Today

[mopar66]

Picked these up today. The Vidmar is pretty beat and a little crusty/rusty. The Lista does not look great the paint looks worse than the pics show. Has some pitting in the paint but the drawers open and close great. It is way bigger than I thought it was going to be. But at $400 for the pair I just couldn't walk away.

 

[mopar66]

The Lista is 28.5 D, 49.25 H, 56.5 W and the Vidmar is 27.75 D, 59.25 H, 30 W.

 

[tool_scrounge]

Before you fill them up, takes them apart and clean/lubricate the drawer rollers (presuming they are the metal roller bearing type).

 

[CNGsaves]

Damn, that is smokin' deal at $400 for the pair . . . . YOU **** !!

I was watching a couple smaller Stanley Vidmars on GovLiquidation that ended up being around $400 for the pair . . . .but only 9 drawers total and smaller. The 4 1/2 hour round trip to go pickup also convinced me to skip, along with fact that I'd need to paint them to match.

 

[mopar66]

It was a 4 1/2 hour round trip for me and I almost didn't take the ride.

 

[mopar66]

So I sold the vidmar it just didn't fit well in my garage. I passed along the good deal I got for $275 delivered. So the Lista stands me $125.

 

[sidd_V]

Since a couple of years I have been looking for matching lista's. I started out with a plns cabinet wich I traded for 4 small 7 drawers cabinets. I sold those to buy 3 90cm wide drawer cabinets. (black and blue set)
And in turn again got sold off to buy the lista's

I had to pay 800€ for the set, both 54" 8 drawers and took me about a 4 hours round trip. Due to the upgrading over the years i still have a overall profit of 400 €. Needless to say this is going to be spend on partitions and boxes

Verstuurd vanaf mijn SM-G920F met Tapatalk

 

[Trey T]

OP: @33/dr, it's a good deal!!! However, is that the drawer configuration that you need?

I had a 56" lista came through but the top drawers weren't shallow enough to replace my other lista cabinet and workbench. The 56" width drawer is very awesome!!!