BPs new weld/fab table

[BPJOOP93]

The top is 60x41 half inch plate. 14 receivers around the perimeter. Tool box, metal storage, and three stubs for my vises. Couple of pictures and hopefully a short video. If you see anything that you would add let me know. I am going to paint it once the weather warms up some more. If I had to guess the weight of this 700# maybe ????? Money wise around $200 invested.

 

[BPJOOP93]

Here's some more pics. The height is 39 inches. I'm 6'4" so that's a good height for me.

 

[2oolhound]

Nice work. I see a lot of welding table where the receiver hitches are added under the main frame tubes. With that setup the slider on the dynamic jaw hits the top of the table so you have to make the vise stick out further. With your setup the slider will sit above the top of the table.

 

[BPJOOP93]

Thanks for the words. For some reason, probably me I can't load the walk around video. A big shout out for all the members that posted their builds. Got ALOT of ideas from all of you.

 

[BFHammer]

Nice table. That many receiver points should give you plenty of options.

Almost done with my table now - it's 37" and I'm 6'2". Glad to know I got my math right!

 

[y'sguy]

you get extra pts from me on your caster setup. That is also my favorite way of doing it. It seems I don't see it done that often, but to me it makes more sense. Great work.

 

[John15511]

Great job! That's pretty inspiring to many of us searching for ideas