Bridgeport EZ Track mill - hard drive failed

[primergy]

Hi all,

The DOM (disk on module) / hard drive on my Bridgeport failed and I do not have a backup. No, it does not boot from a floppy, instead there is a 8MB module, similar to modern-day Solid State Drives. I can replace the drive, no problem, but:

Would anyone have a source, or a lead on how to get a hand on the Bridgeport EZ SPS software?
I called a few suppliers and service folks and no one has it.
Seem like there were not too many of this mill version around.

Many thanks in advance.

 

[JohnK007]

Can't help you directly, but join and post your message on Practical Machinist. Someone there might be able to help. They have a Bridgeport sub-forum.

 

[Griff93]

Have you tried the guys at BPT service? They claim to have all the bridgeport cnc software. Is yours DX32 or SX15?

 

[cnc-me]

I have software for the SX and DX somewhere. Is it similar to the V2XT?

 

[bullnerd]

Good luck dude, frustrating when the older stuff breaks down.

I went to use my p-trak after it sat for a few months and found a mouse chewed through the fan guard and made a nest inside. No more monitor!