Calling all snap on krl756 owners

[Craigmcfarlane]

Currently waiting in the arrival of a krl 756 but the only doubt I have with it is the height of the top drawer. Could anyone measure the height for me as I have socket trays which hold all my sockets upright and am particularly concerned about my half inch deep sets as the total height is 3.5 inches. Does anyone know if I am able to stand these upright or will I have to rearrange my sockets?

Thanks

 

[Wamsutta]

From the drawer liner to the top of the rolled edge is somewhere between 3-13/16'' and 3-7/8''. But that's measuring the top drawer of a KRL1056, so you might want to disregard that measurement.

 

[chrisnazzy]

My first Snap-on box was a KRL756. It was later replaced by my current box, a KRL1001.

Both boxes have the same top drawer height. These drawers are often referred to as 4" drawers although I'm well aware that they are actually not quite 4" tall.

I've never had any problem fitting deep 1/2" sockets, both chrome and impact, standing upright in the drawer even with plastic socket trays. I currently have Snap-on, Craftsman and Sunex 1/2" sockets upright in the drawer. I would imagine thicker rails or socket trays may not work. I just went and took these pics for you.

Sent from my SM-G965U using Tapatalk

 

[chrisnazzy]

From the drawer liner to the top of the rolled edge is somewhere between 3-13/16'' and 3-7/8''. But that's measuring the top drawer of a KRL1056, so you might want to disregard that measurement.

Your KRL1056 would be the same.

Sent from my SM-G965U using Tapatalk

 

[Craigmcfarlane]

From the drawer liner to the top of the rolled edge is somewhere between 3-13/16'' and 3-7/8''. But that's measuring the top drawer of a KRL1056, so you might want to disregard that measurement.

Thanks man

 

[Craigmcfarlane]

Very helpful I appreciate it man, I have the same trays as you so I do not think there will be a problem now!