Can PVC LQ be installed inside Stud Walls

[mobiledynamics]

Cost aside, I'm looking for something ~smooth~ - not corrugated (carlon) to run some low voltage . Is LQ okay to run within walls...

 

[ADSR]

Pvc lq?

 

[zmaxmotorsports]

Pvc lq?

 

[Stuart in MN]

I think he means liquidtight nonmetallic flex conduit.

 

[Norcal]

Not going to be much fun to pull anything through in the future. Use EMT or PVC.

 

[mobiledynamics]

Isn't NM liquidtight smooth wall in the interior ?
I'm talking 1 1/4" as this is the largest I can run inside the stud bay..
Not terribly long. About 15-20 feet

 

[zmaxmotorsports]

Isn't NM liquidtight smooth wall in the interior ?
I'm talking 1 1/4" as this is the largest I can run inside the stud bay..
Not terribly long. About 15-20 feet

Seal tite is a major pain in the *** to pull wire through unless ites short/straight.

 

[mobiledynamics]

Carlon is just as bad right since its corrugated ?

 

[mobiledynamics]

I'm leaning on flex just due to the route it will be in the studs

 

[Pwrgeek]

I'd put a string in it before I put it in. I'm assuming you want flex because it will have bends (otherwise pvc or met would work). Flex with bends inside a wall is going to be a nightmare to fish later (thus the recommendation to pull a string in it now).


Sent from my iPhone using Tapatalk