Can someone identify this

[1930]

Made by Industro. Spring loaded lever pushes out what looks like a feeler gauge which comes out of a socket end. The other end has two little tangs with a hole in the center.

 

[bgarrett]

I take it that papawswrench was no help?

 

[hippie2cams]

I think that is an old distributor tool the end with the feeler gauge is for the points, the end with the tabs is actually a screw driver for the screws in the distributor holding the points and condenser. I have not seen one in a long time so its possible I'm wrong.

 

[joel63]

I think that is an old distributor tool the end with the feeler gauge is for the points, the end with the tabs is actually a screw driver for the screws in the distributor holding the points and condenser. I have not seen one in a long time so its possible I'm wrong.

A Delco distributor tool for early model Chevy 6 cylinder engines.

Maybe a little different?


http://www.ebay.com/itm/Snap-On-MD1...11-32-Hex-Head-Pronged-GM-Delco-/121298921364

Google Snap On MD17.

 

[1930]

I take it that papawswrench was no help?

No reply

 

[1930]

Thanks to both of you, I am sure that is it cause there were other early ignition tools in the pile. Thanks again