Carburetor Jet Wrench?

[Provincial]

This tool was in a group buy from the Flea Market. The outside diameter of the working end is 5/16" diameter, and the lugs are about 1/16" wide. It looks like some carburetor jet tools, but maybe for something else. Perhaps for bezels on dash controls? I can't find any markings on it.

 

[Oldtuleguy]

It's pretty big for a carb tool. Maybe a dashnut?

 

[driftpin]

I have a couple bezel tools like that, one for Tri-Five GM windshield wipers and one for interior dash bezels for controls. Not exactly the same but the same general purpose/style.

 

[cgrutt]

Possibly vintage ignition wrench?

Mavin | Chevrolet K-D NO.112 Ignition Point Wrench For Chevrolets 1953-1954 Vintage Tool

Mavin.io - Chevrolet K-D NO.112 Ignition Point Wrench For Chevrolets 1953-1954 Vintage Tool

mavin.io

 

[Provincial]

That looks very similar, although beefier. Any idea where the fastener was that is was used on?

 

[Marsim]

Valve stem remover? I use a few at work that look similar to that.

 

[Zrxrunner]

Looks just about like the snap on special socket I got recently. Part number said it was for old car radio knob removal. Not sure which years or makes tho.

 

[cgrutt]

Looks just about like the snap on special socket I got recently. Part number said it was for old car radio knob removal. Not sure which years or makes tho.

I have a set of Snap on sockets that look similar but they were for car stereo antenna installation/removal. They're larger than 5/16" though.

 

[Zrxrunner]

Don't have a pic of mine, but search snap on s9605a or s9605b. 1/4 drive, comparable size of a 1/2" socket I would say. I'll try n attach a picture of mine after work