cincinnati No.2 horz.mill

[Glen Taylor]

The lever for the feed trip linkage broke and the operator did not stop the table before it reached the limit. Now only the rapid feed works for the table feed.Do i have to remove the knee to repair whats broken? Thanks, the machine is a 1951.

 

[454ragtop]

Practical Machinist (.com) will be your best bet for help with this.

 

[blazemaster83]

It may be a sheared key or broken pin, not sure on the cincinnati's. It also could be much worse though, you could of chewed up a feed gear. Not much else to do except get a parts manual and start digging into it.

454ragtop is right though, you are asking the wrong forum.