whateg01
Well-known member
I decided to get my old 101.03580 in service after it being in the corner collecting dust for several years. I picked up a baldor motor a few years ago because this will be a working drill press. But the switch that was on it was **** wrapped in electrical tape. I wanted something a step up from a light switch but there isn't really room for a nice two button Cutler hammer. Decided a toggle switch mounted on the side near the front was best but there's not much room there. I'm not 100% in love with the look. I think an old WT switch would look nicer, but this works and is still safe.
