Compessor ID

[frozen-stitches]

My dad has a compressor he's trying to get a little info about. We believe it is a 60 gallon tank. Does any one know the pressure and cfm of this pump and the tanks max pressure

Sent from my iPhone using Tapatalk

 

[C96]

All the components of this compressor look to be replacements. Looking at the tank mounting skid there seems to be an abundance of different mounting holes. The pump, electric motor and air filter being of a different color could also be a clue these components have been changed out at some point. The galvanized plumbing pipe between the high side cylinder / aftercooler also indicates changes, a Frankenstein compressor so to speak. Not that its bad or anything, actually looks to have been done quite tactfully.

It’s hard to tell from the picture, but it looks like the tank placard is stating 200 psi.

To get specs for the pump, serial numbers / casting numbers would need to be investigated.

 

[MacMcMacmac]

It's a Schulz pump, made in Brazil.

http://www.schulzamerica.com/products/compressor-pumps/two-stages/max-v-175psi/

I think they have transposed a bunch of numbers in the spec table for the 7.5hp pump.

 

[frozen-stitches]

thanks for the info on the pump. i'll probably score the pump and motor. we tried opening the inspection holes but they are rusted shut. my dad has been kind of worried about the tanks age and condition. he just bought a new IR 2 stage 80 gallon. we believe the tank to be around 30 years old and don't know how well it is since when we have been draining it and have been finding chunks of rust.