Digital4n6
Well-known member
I would like to install an outdoor air compressor fitting.
Running the RapidAir piping through an unfinished basement rafters to a Milton Filter Regulator Lubricator (1/2in. Inlet) on the interior side of a concrete wall then plan to plumb 1/2" cast iron pipe through the masonry to an external fitting.
Should any standard 45-degree fitting be good, then place it under some sort of weatherproof electrical box outlet cover housing? Here is a picture of what I was considering.
Will run an identical box for a 20amp outlet (not double gang, separate boxes for safety) and have it near my generator outlet box as well.
Running the RapidAir piping through an unfinished basement rafters to a Milton Filter Regulator Lubricator (1/2in. Inlet) on the interior side of a concrete wall then plan to plumb 1/2" cast iron pipe through the masonry to an external fitting.
Should any standard 45-degree fitting be good, then place it under some sort of weatherproof electrical box outlet cover housing? Here is a picture of what I was considering.
Will run an identical box for a 20amp outlet (not double gang, separate boxes for safety) and have it near my generator outlet box as well.
