Crack / void filler, self leveler, for factory floor?

[jake00]

Here’s a couple pics of our wood shop floor, it’s an 80 year old building , concrete floor that has some areas that have been patched before.

We push carts of wood / lumber over this area every day, What’s the best product to use, The first 2 pics are a void about 6” long 1/2” deep 1/2” wide The next is an area we want to level, (it doesn’t need to be level per se, but smooth) We’ve tried products like jiffset and they don’t last

 

[jake00]

Anyone?

 

[LegacyIndustrial]

Jake:
Resurface and Patch: https://www.legacyindustrial.net/products/concrete-repair/hd-110-epoxy-concrete-patch.html

Cracks, small holes (wide or thin):
https://www.legacyindustrial.net/products/crack-joint-products/

Good luck!

 

[FJ4FUN]

Check out:

TrowelEase 1162

If you're just filling cracks and voids and are not intending to apply an epoxy overcoat then just prime the repair areas only with BondTite 1101.

 

[Shea]

The suggestions above are all excellent choices. They will provide a repair that many times is stronger than the surrounding concrete. They key though is to make sure to remove all the loose material that you can first. Don't just clean the area out apply the product. Take a hefty hammer and chisel to the area. Any soft or loose material will be exposed this way and you will have a much better repair.

 

[FJ4FUN]

Shea is correct, we go over this in the application instructions linked above.

 

[jake00]

Thanks guys. ALPHA, can your product be used outside? I’ve got a ramp that needs some repairs too.