Craftman table saw / jointer combo

[Hadsall]

Just bought this little home combo unit and having a bit of a problem identifying the year mid 40s early 50s ? Also havn't got a clue as to its value any input would be welcome! Thanks!

 

[Zeke]

That's a nice saw, 100 series I believe. I haven't seen the jointer option before although Rockwell had one but at a lower elevation. The stand is worth good money. The OWWM site has lot of info on that. If you're local to me, bring it on over and I'll buy it.

 

[jakemac]

The first thread you started about this can be found here :
http://www.garagejournal.com/forum/showthread.php?p=5191160#post5191160

It's good to see pictures this time around.

 

[zkling]

That should be an 8" saw, shame the extension holes got broken out. They are pretty limited as far as work capacity, so outside of a collector, not much...i see them quite often in the sub 125 range.