Craftsman 100 main pulley dimensions

[frugalguido]

Does anyone have a pulley out of their drill press that could do some measurements for me? I need the length of the shaft from the surface that the top bearing rests on to the end where the splines are. The one I have appears to be short compared to the ones I see online. I'm going to make a new shaft and get rid of the poor Zamak one ( worn splines and shaft).

 

[FrankLee]

I measured 3-5/16".

 

[frugalguido]

Thank you very much, mine measures only 3". So is the actual spline length about .625" - .750"?

 

[FrankLee]

So is the actual spline length about .625" - .750"?

Yes. I believe closer to 5/8".

 

[frugalguido]

Ok thanks for the info.