Craftsman 113.27520 Table Saw

[damnesia]

Picked this up for 20$ yesterday, to replace my cheap ***, aluminum delta table saw. I'll buy just about anything with engine turning decoration on it Came with the original stand too. A 10" made by King Seeley, with a 1HP working motor. The speed handle on one of the knobs is missing and the geared fence is broken at the end, going to try to find those. These things are abundant so I'm hoping someone here has parts.

 

[thehorse13]

I restored one of those last year. From what I see in the pictures, you have plenty of work ahead of you.

The 1HP motor is the one you want on that rig. The smaller ones don't hold up as well to heavy lumber.

 

[damnesia]

I doubt I'll spend to much time on it, except cleaning the top and rewiring it. More than likely replace the bearings in the motor, although it runs well. Basically just clean it up and let it sit until I need it. Slowly pick up parts on ebay unless someone here has them. I rarely build things with wood, but when I do it's nice to have a good table saw.

 

[MrCat63]

Nice find for $20. I'm gonna take a peek in my box of parts this evening and see if I've got a handle for you.

Mark

I do have a complete handle. It's a bit pitted but in working order. Yours if you want it, let me know.

 

[pdubss]

I have a front engine turned panel

Sent from my SM-G930P using Tapatalk

 

[damnesia]

PMs sent.

 

[SweetD]

Rode hard, put up wet, but you can make it a nice runner again I'm sure.

Nice find!

 

[pdubss]

The pencil is pointing at a dent. It took some "persuasion" to get off the tilt handle!

Sent from my SM-G930P using Tapatalk

 

[MrCat63]

PMs sent.

Sent pm, ran out of town a couple days. Back now and ready to watch the refurb.