Craftsman block grinder wiring help

[MBetz04]

I just picked up a craftsman block grinder and I noticed the light has a separate cord wired for 120 but the grinder has a 240 cord. When I found the wiring diagram it didn’t reflect there being two cords. I was wondering if this is normal and if it will be hard to switch everything back to 120 v. I am new to wiring these so I need to know what supplies I will need. I have a ratcheting crimper and wire stripper from when I rewired my boat.

 

[exmaxima1]

Maybe the 120 cord is solely for the lamp.

 

[FrankLee]

I just picked up a craftsman block grinder and I noticed the light has a separate cord wired for 120 but the grinder has a 240 cord. When I found the wiring diagram it didn’t reflect there being two cords. I was wondering if this is normal and if it will be hard to switch everything back to 120 v. I am new to wiring these so I need to know what supplies I will need. I have a ratcheting crimper and wire stripper from when I rewired my boat.

It should not be difficult to switch back to 115v.

Remove the bottom cover, take a photo and post it here.

 

[Eric Brown]

According to the drawings the lamp is listed. The two wires are going to different points. If switching from 220 to 120 just follow the drawing on the left.