Craftsman DA sander pad replacement

[bigpokie]

I've have my da for 7-10 years now and the pad has ripped off of it. It's a model 875, I think. Does anyone know or has done it ? I would ask dears but I'm surprised those employees can make it to work.

 

[Cypherian]

I have replaced them on Claytons, IR's, Blue Points etc it can be done the biggest pain in the **** will be the wrench needed to hold the drive spindle so you can back the pad off. Check Sears Parts for a new pad and see if there is a special wrench for the drive spindle. You might be able to dummy one up out of flat stock if you can get an accurate size for the spindle nut.

Sears Part number Pad Part #: 5416G

http://www.searspartsdirect.com/model-part/875199761/0247/0743000/50033179/00001.html

Cypher

 

[LB-1911]

This 1?

SANDER Diagram and Parts List for CRAFTSMAN Sander-Parts model # 875199761
Pad
Part #: 5416G

http://www.searspartsdirect.com/model-part/875199761/0247/0743000/50033179/00001.html


Shows Pad Obsolete - Not Available @
http://www.ereplacementparts.com/cr...tion-sander-parts-c-158286_162684_162690.html


875 = Florida Pneumatic
http://www.florida-pneumatic.com/

 

[bigpokie]

It's not those. It's a palm style. Had the lever on top, that if your holding on to it, starts at the wrist and goes to your fingers

I did find this

http://www.ereplacementparts.com/craftsman-875199601-sander-parts-c-158286_162684_162778.html

But I'm out of town right now so I'm not 100% sure