Craftsman impact on Hansen rails?

[Timothayyy]

Im thinking about buying the 95 piece Craftsman impact set and I was wondering if they will all fit nicely next too each other on the Hansen rails or are they too wide?

 

[McKay]

They will fit. However some of the really small 1/4" and 5/16" Deep 3/8" drive will not fit on the shaft.

 

[gj67stang]

I had problems fitting the 9/16 " and 5/8" 1/2" deep on the pegs.

Threw 'em on the lathe and bored out the thru-hole a few thousandths larger and they fit over the pegs fine then.

 

[bcradio]

I got the 95 pc and it fit on the HF socket trays just fine with no mods needed

 

[Mr Ratchet]

My CM impact sockets fit on my Hansen just fine. I did have to slightly drill out a few chrome sockets to slide freely on some of the pegs.

 

[NastyNate]

The older V series impact would not fit on my Hansen tray. Not the pegs but the over all size of the socket. There wasnt enough room side to side.