You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
craftsman impact wrench ceramic balls
- Thread starter gungatim
- Start date
lbhsbz
Well-known member
Were they in the outlet side or the inlet? If in the outlet, I'd assume some sort of an attempt at a muffler.
got it back together and still no worky...turns out one of the rotor blades was defective, big crack in the middle and won't fit the slot correctly, so it jams when it makes a revolution. gotta buy a new one of those somewhere.
when I took it apart the 3rd time, the impact end fell out of the housing, it was very oily, so I THINK it was supposed to be filled with some type of oil. anyone know what to use? it didn't stink like gear oil, I am going to assume it's just 30 wt...
all in all, I think I am done with cheap air tools...though my HF Earthquake is still going strong after 20 yrs or so...
Sad state of affairs with the Craftsman brand. I'm sure there are still a few good tools out there but the last couple I have purchased were duds.... I'd avoid their digital torque wrenches. I got about 12 bolts torqued with the 1/2 one I had before it broke on me, right in the middle of putting the lift system on my truck. Was a pain in the **** to go to Lowes and buy there 1/2 version but so far it's holding up.