Craftsman Model 103 table saw fence

[Clemente]

I inherited my dad's early 1950's table saw not too long ago. I swapped the 1/2 HP motor for a 3/4 motor and it's running well, but the cam-lock fence didn't lock. I found a replacement, but now it's not locking either.
Can these old fences be adjusted or refurbished? There appears to be an adjustment screw at the tail end of the fence but the slot is split by the rod running through the fence.
Any help is appreciated!

 

[Cope]

Look at Vega fences. They may have a fence for your old saw. They are available everywhere.

http://vegawoodworking.com/product-category/table-saw-fences/

 

[thehorse13]

I just went through this exact issue with mine. The fence can be adjusted. PM me with your e-mail address and I will send over the PDF manual. It discusses adjusting the lock rod which worked perfectly for me.

 

[Valfax]

I just went through this exact issue with mine. The fence can be adjusted. PM me with your e-mail address and I will send over the PDF manual. It discusses adjusting the lock rod which worked perfectly for me.

Would you happen to still have access to that psd for a 103 table saw fence ? My email is [email protected] if it’s not to much trouble.

 

[thehorse13]

Would you happen to still have access to that psd for a 103 table saw fence ? My email is [email protected] if it’s not to much trouble.

8 years ago I had the PDF, but I don't anymore. I sold the saw and have long since deleted the file. That said, you might find it here:

Internet Archive: Digital Library of Free & Borrowable Texts, Movies, Music & Wayback Machine

archive.org

 

[RTM]

Would you happen to still have access to that psd for a 103 table saw fence ? My email is [email protected] if it’s not to much trouble.

Might have better luck here,

Sears | Craftsman - Publication Reprints | VintageMachinery.org

Select the pull down for table saws, then search for your model number