Craftsman power hacksaw

[whatupjoe40]

Hi could someone help me out here please. Looking for 556-289 raising leverage plates. Could someone lead me to where I can buy some or have the dimensions of the raising lever plates so I can make some. You can email me:
[email protected]

PS.#7 in the picture.

 

[lilredex]

Those are easily made from any 1/8" steel material. I use those hardware store reinforcing plates. Dimensions can be scaled from the picture included. The length is not critical, adustments are made with the adjusting bolts, under pt #9. Sharpen the end at a 45* to fit the feed block. Width to fit on pt #9.

Where are you located? Always nice to know.

Power hacksaw craftsman 108 1502

Looking for information on a Power hacksaw craftsman 108 1502. HELP!

www.garagejournal.com