Craftsman Screwdriver circle F

[alton1911]

I have seen lots of 90 degree screw drivers but this is my new favorite. Not familiar with the circle f, and to be honest, this looks way too well built to be a normal screwdriver. If anyone has information on any specific application it would have been used on, I would be grateful.

Thanks again,
alton1911

 

[four.cycle]

F-circle = Miller Falls, ca. 1949 - 1964

pretty sure they were re-branding that unit for several different manufacturers.

 

[alton1911]

It is very cool. The square stock handle made me think it might’ve had a specific purpose.
Thanks again for the information.
alton1911

 

[markhm]

They were commonly sold in the Sears stores for general purpose use. I bought several. I liked that they worked in tight quarters and each of the 4 slotted tips was set at a different angle to give you max access to the screw slot and max ability to turn the screw.