Craftsman Torque Wrench 9-31425 case

[BCKinVT]

I recently purchased a Craftsman 9-31425 Microtork 1/2" drive torque wrench. It came in a plastic tray, but I would like to find a molded case for storage as I tend to leave this in the Jeep.

I'm hoping someone here can help me find a source for a case. I obtained a NOS Craftsman 9-44024 red molded case that I thought would fit, but it's too small - probably for a 3/8". This wrench is 21" long.

 

[gdocktor3]

I have one like that I bought a few years ago. I thought it came with a hard clear plastic cover that was screwed on. If yours did, I would save it and just use that. I don't think you will find an exact case for it. I'd email or call Craftsman and ask. You can find the info on the website under customer care.

 

[drink]

You might try calling Armstrong technical support and ask them which of their cases will fit your wrench. Then you can get the item number from them if they have a matching case. I found a few cases but you will have to ask the mfg's if your tool will fit.

http://www.all-spec.com/products/64-298.html?gclid=CM3BgIy6ossCFU07gQodOlsOmg

https://www.zoro.com/proto-blow-mol...gclid=CM_b5Yi6ossCFdgNgQodxfoIww&gclsrc=aw.ds

http://www.mscdirect.com/browse/tnp...gle-PLA+-+Test&CS_003=7867724&CS_010=40093007

http://www.mscdirect.com/browse/tnp...gle-PLA+-+Test&CS_003=7867724&CS_010=40093015

If you find a match then you can shop for the best deal.

 

[BCKinVT]

This helps - Thanks!

 

[panknuckshovel]

If all else fails and you cant find an actual case you could fab one up out of pvc.

 

[zendriver]

I have one of those, also and was most annoyed, they just simply could not put it in a real carry case.

You could always get a $9.99 HF clicker and just use the nice carry case, it comes in.

 

[LB-1911]

I'm hoping someone here can help me find a source for a case. I obtained a NOS Craftsman 9-44024 red molded case that I thought would fit, but it's too small - probably for a 3/8". This wrench is 21" long.

Optional Torque wrench storage case for ATD-101
Dimensions: 22.25" long 2.5" wide outside. 21" long handle 1/5" wide inside.
http://www.tooldesk.com/automotive/ATD121-Optional-Torque-wrench-storage-case-for-ATD101.aspx


http://atdtools.com/123

The spec's seem to be hit or miss.