Craftsman Vise Jaws 51865

[Dalez]

Don't have enough posts to put this in the wanted section so I will try here until my post count gets up.

The Jaw faces are no longer available but there must be some other manufacturers that will fit.

The measurements are 4.5" x 1/4" maybe 5/16" thick and 5/8" high. Screw holes are 2.5" center to center.

I searched myself into a stuper but they just don't offer enough info about the screw holes to make a purchase. If anyone can help it would be much appreciated.

Thanks,
Dale

 

[Mike in Ohio]

I am in the same boat I need a set of jaws for an old Mac vise. I haven't been able to find a site to look for them by the jaw dimensions.

 

[AngryBeaver]

check on eBay under the seller autopts. he sells many jaws for the craftsman and wiltons

 

[Dalez]

He has them. Thank you