supersteve
Well-known member
Don't know if this will do the OP any good but here is what I have been doing the past month or so.
The guys who mention about having tools but no parts have a point so I have been collecting up some used/serviceable parts where I can for free or cheap. To verify the functionality of these parts I have installed them when I can and then put the known good parts removed in my stash.
Here is what i have so far:
-used waterpump w/new gasket
-ignition coil w/igniter
-PCM
-plugs (lol all three)
-wiper motor
-misc fuses and relays
-water and air temp sensors
-timing belt
-timing belt tensioner
-fuel filter
-injector resistor
-MAP sensor
-distributor w/cap/rotor/wire
-antifreeze
I plan on getting:
-fuel injector
-alternator
-alternator belt
-oil filter w/3 quarts
It seems like a lot but this will fit behind the seats on a long trip. They are each in a ziploc bag and then carefully wrapped in paper.
My tools are tailored specifically for the Clown Car (8,10,12,14,etc.) and are going in some tool wraps under the seats.
The guys who mention about having tools but no parts have a point so I have been collecting up some used/serviceable parts where I can for free or cheap. To verify the functionality of these parts I have installed them when I can and then put the known good parts removed in my stash.
Here is what i have so far:
-used waterpump w/new gasket
-ignition coil w/igniter
-PCM
-plugs (lol all three)
-wiper motor
-misc fuses and relays
-water and air temp sensors
-timing belt
-timing belt tensioner
-fuel filter
-injector resistor
-MAP sensor
-distributor w/cap/rotor/wire
-antifreeze
I plan on getting:
-fuel injector
-alternator
-alternator belt
-oil filter w/3 quarts
It seems like a lot but this will fit behind the seats on a long trip. They are each in a ziploc bag and then carefully wrapped in paper.
My tools are tailored specifically for the Clown Car (8,10,12,14,etc.) and are going in some tool wraps under the seats.
Last edited:


