Custom Socket Holder

[Angry welder]

So I had some free time out in the garage today and put these together. I still have to paint them and do some finish sanding, but they are working out great so far. I still need to finish the metric 3/8 sockets and the 1/2 drive stuff also. I may do a video about them later if anyone is interested in hit me up.

 

[Basher]

Looks neat -
& makes it very easy to see any that may have gone astray,
After a busy session in the garage that should make for less anger, too!



Keep at it

 

[Spinaker01]

Very nice! I have been toying with the idea of something similar to that but made out of Aluminum. I just need to finalize my drawer/socket configuration first or make some smaller modular units that can be re-arranged as needs change. Will keep an eye out for this thread as it develops.

 

[Duth62]

Very nice! I have been toying with the idea of something similar to that but made out of Aluminum. I just need to finalize my drawer/socket configuration first or make some smaller modular units that can be re-arranged as needs change. Will keep an eye out for this thread as it develops.

I did some out of aluminum and drilled-tapped for Allen cap head screws.
I put a piece of vacuum hose over them leaving the head exposed. Came out slick.
I hope the scumbag that stole them likes them.It was a lot of work. A quick call to JB and I was swimming in Gearwrench rail sets in a couple of days.
I actually like them better. You can grab a couple of rails and shove them in your pockets or toss them on the seat.