So I noticed that the seal along the bottom of one of our basement walk-out doors is off and laying on the ground. Being the father of a 17 year old boy who has crammed the basement full of ATVs and mini-bikes, I naturally think he is somehow to blame.
I go to re-install the weather seal, only to find that there is no more bottom to the door! It's a metal faced exterior door, with wood around the edges and foam core.
The wood is COMPLETELY gone along the bottom, and up the side to the base of the hing. There looks to be a little loss starting on the door case opposite this area too.
I poked around a bit on the stack of studs in the wall that the door frame is attached to (unfinished basement) and they seem solid, but I'm going to poke harder, and maybe take a core-sample or two with a small drillbit... if wood comes out, I'm fine. If fluff comes out, I'm screwed.
There was a pile of dirt on the floor there, and I thought it was dirt from the kid leaving the door open all the time, or that it was dirt that had just accumulated. Turns out it's the dust and crumbs from the bugs.
I have not actually seen any of them, but wood doesn't just disappear.
So the plan is go mix up a batch of Pre-Core and HyKill and hose the area down inside and out. I'll also take off the siding along that area outside, and hose it down as well.
Then I'll have to rebuild the door and replace that section of door frame as well.
I've needed an excuse to get a table saw, so it's not all bad.
I'll have to check the rest of the wall too.
So other than the Pre-core/HyKill bath, anyone have any suggestions?
-Brad
I go to re-install the weather seal, only to find that there is no more bottom to the door! It's a metal faced exterior door, with wood around the edges and foam core.
The wood is COMPLETELY gone along the bottom, and up the side to the base of the hing. There looks to be a little loss starting on the door case opposite this area too.
I poked around a bit on the stack of studs in the wall that the door frame is attached to (unfinished basement) and they seem solid, but I'm going to poke harder, and maybe take a core-sample or two with a small drillbit... if wood comes out, I'm fine. If fluff comes out, I'm screwed.
There was a pile of dirt on the floor there, and I thought it was dirt from the kid leaving the door open all the time, or that it was dirt that had just accumulated. Turns out it's the dust and crumbs from the bugs.
I have not actually seen any of them, but wood doesn't just disappear.
So the plan is go mix up a batch of Pre-Core and HyKill and hose the area down inside and out. I'll also take off the siding along that area outside, and hose it down as well.
Then I'll have to rebuild the door and replace that section of door frame as well.
I've needed an excuse to get a table saw, so it's not all bad.
I'll have to check the rest of the wall too.
So other than the Pre-core/HyKill bath, anyone have any suggestions?
-Brad

