Decided to DIY using Supercoat from Sam's Club

[Svtcobra66]

I used the included degreaser and a wire brush, and also pressure washed it out a few times for prep. If I had to do it again I'd probably rent a floor grinder just to make it easier and get rid of the concrete imperfections, which the slate gray color kinda highlights. Gave it a day before applying the epoxy and another day for the glaze coat. Pretty happy with the results. I used 3 kits for a three car garage, so under $300 total. I gave it a week before parking on it and thankfully no hot tire peel... Yet.

 

[SolarColumbia]

Looks good. That's ridiculously inexpensive, too!

 

[Svtcobra66]

Thanks. I've read that the acrylic top coat that comes with the kit doesn't hold up as well as a more expensive top coat, but for the money you can't beat it.

 

[James-W]

I hope it works out for you. It would be interesting if you would make a post in about a year as to how well it has held up.

 

[gcretro]

I used the included degreaser and a wire brush, and also pressure washed it out a few times for prep. If I had to do it again I'd probably rent a floor grinder just to make it easier and get rid of the concrete imperfections, which the slate gray color kinda highlights. Gave it a day before applying the epoxy and another day for the glaze coat. Pretty happy with the results. I used 3 kits for a three car garage, so under $300 total. I gave it a week before parking on it and thankfully no hot tire peel... Yet.

Did you get to do multiple coats of the epoxy? or was it just one coat?

how was the finish before applying the clear coat? I assume you mixed the anti-slip into the clear coat?

 

[Benw455]

looks good keep us posted

 

[regguy1]

I did mine in the Supercoat June 2010 and it's still in good condition. Has some chips mainly on the lift side where repair work is done.
see it here: https://www.garagejournal.com/forum/showthread.php?t=66867

Here is the garage as it has been used over time: https://www.garagejournal.com/forum/showthread.php?t=140674

 

[PNWguy]

I did mine in the Supercoat June 2010 and it's still in good condition. Has some chips mainly on the lift side where repair work is done.
see it here: https://www.garagejournal.com/forum/showthread.php?t=66867

Here is the garage as it has been used over time: https://www.garagejournal.com/forum/showthread.php?t=140674

10 years later and it still looks good? Impressive.

 

[nadogail]

Thanks for the information.