Sub Dude
Well-known member
I just purchased a mid 80's table saw to restore and I noticed that the far end die cast clamp part is broke. Yup, same as everyone else.
I'm sure that many table 10" including possibly a unisaw fence part would work. It clamps a 1 3/8" tube rail.
If you have one you care to sell, let me know.
Or if you have any ideas on how to repair let me know. JB weld may be tricky because of the hollow channel the clamp piece needs to go through. I don't think there is a lot of stress on this part with normal use. Its just delicate if it gets bumped.
Thanks
Sub
I'm sure that many table 10" including possibly a unisaw fence part would work. It clamps a 1 3/8" tube rail.
If you have one you care to sell, let me know.
Or if you have any ideas on how to repair let me know. JB weld may be tricky because of the hollow channel the clamp piece needs to go through. I don't think there is a lot of stress on this part with normal use. Its just delicate if it gets bumped.
Thanks
Sub
