Delta Drill Press

[tin medic]

What would you guys give for this? It works just fine. Thinking about replacing my Craftsman press with this.






Sent from my iPhone using Tapatalk Pro

 

[twertsy]

The table is likely more expensive than the press. Personally, I'm looking for a freestander so I haven't kept up on pricing on these.

Sent from my VS990 using Tapatalk

 

[tin medic]

They are asking 175. My 50’s Craftsman is free standing..


Sent from my iPhone using Tapatalk Pro

 

[McFarmer]

Check for run out on the quill, then it's a good price.

 

[tombell572]

If that's a board or some type of cover over the table you may want to know the condition of the actual D/P table underneath. Chuck a bit in it and see how true it runs. In addition to quill condition as noted by McFarmer, chuck jaws wear and you may get some pretty nasty wobble.

If all good, $150-175 seems fair.

Tom B.

 

[tin medic]

I ended up passing on it. Nice enough but not really room for it.