Delta Rockwell three bank drill press

[bobbleheadhillbilly]

I found a table that I would like to get for doing welding and such. I just don't know what would be a reasonable offer to make on it. It is approximately 5' long and 2' deep. No drill heads just the table. It has some miles on it and has spent the last two years in the elements. Suggestions are appreciated. -Nick

 

[OccupantRJ]

My pricing would be $50 to $100 to purchase, but I'm exposed to a lot of stuff like that. Looks like the left end has been cut off. Usually the coolant tray runs all the way around the table. You would certainly have a relatively flat welding table, with some fixturing hold down holes in it as a bonus.

RJ

 

[bobbleheadhillbilly]

Thanks for the info. The end that appears to be cut off actually has holes in it to mount a matching table to it. I found out earlier that it used to belong to this guys deceased father. I'm kind of curious to see what effect sentimental value has on pricing, but then again he is a business man. -Nick

 

[mister honey]

I've seen that cast iron leg set sell for $200 to a Delta collector.

I'd offer $100 for the whole thing.

Mike