DIY Powertool Drawer Organizer
- Thread starter z-edition 006
- Start date
bradleykd
Well-known member
Looks great man! Definitely a pain trying to neatly organize those things. You came up with a good solution. Even used a drawer I don't really like because it is easy to pile stuff up in there so you have to dig to find anything. Bravo!
pioneer1
Well-known member
Looks great. Why not show how you built it?
Graham08
Well-known member
I like that...it would be a good use of space in the extra deep drawer on my end cabinet.
I agree, I’d like to know how you did it!
k1rodeoboater
Well-known member
Wow you must really like DeWalt 
I'd like to see how you made it as well.
I'd like to see how you made it as well.
OP
z-edition 006
Well-known member
I didn't take any pictures when building it. The organizer is made of 18mm oak, 2mm steel plate, carbon vinyl wrap, PVC rubber car edge trim.
Last edited:
OP
z-edition 006
Well-known member
Wow you must really like DeWalt
I'd like to see how you made it as well.
Most of my tools are Bosch Pro and Makita, i have just a few Dewalt tools.
DJF3
Well-known member
Very nicely done. I found these on the internet. I think I'm going to build one rather than put them in a drawer. 
OP
z-edition 006
Well-known member
Very nicely done. I found these on the internet. I think I'm going to build one rather than put them in a drawer.
Yes it’s depends if you have a big toolbox or not.
Ohmthis
Well-known member
Very nicely done. I found these on the internet. I think I'm going to build one rather than put them in a drawer.
This was the idea I had also. Even though I have a perfect drawer for one, I don’t have that many tools to store. A hanging one would better employ what I have.
Last edited: