do you have a bendpak with a different jack?

[a52-830]

there is a discussion here:

https://www.garagejournal.com/forum/showthread.php?t=343345

but it doesnt seem to feature people who have gotten a different brand rolling bridge jack for their bendpak lift.

i have an HD9, set wide, and am looking for a manual bridge jack.

i dont want air, which leaves out the bendpak option.

i would accept a fixed width jack stand tray, but bendpak only makes one for the HD in the narrow ramp setting.

they sell an adjustable tray, but the usable part is a fixed width, so that i can't put stands close to the ramps (where the frame of the vehicle is). i also think that a jack stand would be more useful if it sat flush with the ramps. since it would then provide even more space for the jacks, since they could partially sit on the ramps themselves (but i digress).

i bought an atlas RJ45:

https://www.atlasautoequipment.com/products/other-products/rolling-jacks/rj45

hoping that the wheels would fit down into the channels on the inside of the ramps, but they dont.

so, who has actually purchased and uses a non bendpak bridge jack on their (hd9) lift? what did you get, and how do you like it?

 

[BMW Rider]

Check the discussion in this thread.

https://www.garagejournal.com/forum/showthread.php?t=343345

 

[a52-830]

Check the discussion in this thread.

https://www.garagejournal.com/forum/showthread.php?t=343345

yes, thank you. i noted that thread at the beginning of my post. unfortunately, it is not flush with people who have done it, it is flush with people who want to do it. this is an attempt to add some experience to the discussion.

 

[RMR&C]

This is my redneck solution......a piece of 3 1/2" glue lam about 18" wide. Slides on the jack rails and sets level with the ramps. Works great so I made a second,