Does anyone know anything about this setup?

[theundecidedt]

Found this on craigslists for a steal. Guy says it is all Delta. I'm planning on going and picking it up on Friday so any input would be appreciated. What should I look at spending?

 

[theundecidedt]

Upon further research the table saw appears to be a Rockwell Delta 34-600 I'm not sure the details on the jointer or router yet though.

 

[ckadams00]

Could be fun depending upon your interest in restoring. Looks like the wiring will need to be addressed, most likely the bearings will need to be replaced. The stand looks very lightweight, but I could be wrong. I haven't found small jointers like that to be all that useful (looks like a 4"? but maybe it's 6"). Could be a useable set up but most probably needs some TLC. What's "a steal"?

 

[Richard Cranium]

that would be a nice set up to have.