dreamingmuscle
Well-known member
Ok I've got my concrete pad scheduled to be poured in two weeks. In the mean time I need to get my power and water ran out there. But I also need to make some of these. They are from Red Caddys thread. http://www.garagejournal.com/forum/showthread.php?t=1534
They are meant to be set in the slab and allow you to slide in 2 inch square tubing in them to mount grinders ETC on or just to pull from. I plan on putting one in each door way and on the opposing end of the garage just in case I need to winch a car into a bay. Also plan to put some just off the door ways.
So any way how long/deep do you think the receiver tubing should be for maximum stability? I looks like his are about 6 inches.
Thanks Glen
They are meant to be set in the slab and allow you to slide in 2 inch square tubing in them to mount grinders ETC on or just to pull from. I plan on putting one in each door way and on the opposing end of the garage just in case I need to winch a car into a bay. Also plan to put some just off the door ways.
So any way how long/deep do you think the receiver tubing should be for maximum stability? I looks like his are about 6 inches.
Thanks Glen

