Looking for slide hammer sets I noticed that not many are made in USA anymore. I really like this set: LINK but made in Taiwan kind of kills it for me. So does Snap-On make a set like this with the deep hub/axle yoke? I can't seem to find it on the site and this would be my most used attachment for the set.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Does Snap-On make a slide hammer like this?
- Thread starter marcusicp
- Start date
Moose-LandTran
Well-known member
No, but you can piece one together from multiple set. Expect to pay a small fortune if you choose to do so.
The Snap-on hub puller is shallow, and the bolt spacing is only really suitable for larger PCDs. They do make a puller with moveable legs though to suit almost any application. Again, this costs a lot.
The Snap-on hub puller is shallow, and the bolt spacing is only really suitable for larger PCDs. They do make a puller with moveable legs though to suit almost any application. Again, this costs a lot.
No, but you can piece one together from multiple set. Expect to pay a small fortune if you choose to do so.
The Snap-on hub puller is shallow, and the bolt spacing is only really suitable for larger PCDs. They do make a puller with moveable legs though to suit almost any application. Again, this costs a lot.
Is this the one you are talking about with the moveable legs? LINK
Moose-LandTran
Well-known member
Is this the one you are talking about with the moveable legs? LINK
Yep. A bargain at only $600!
Yep. A bargain at only $600!
If I am reading this right it has a 1 1/2" - 12tpi slide screw? That's huge! The other Snap-On slide hammers are 3/4" - 16tpi. Do they make any other stuff that uses the 1 1/2" - 12tpi size?