Drawer slides

[PhantomEB]

Long story, short.

Replaced the casters on my international box and a half, top chest & bottom roller with talker ones. Didn't think about the slope of my garage. Well one day I was moving it. One by one drawers opened to the point the ****** mounting screws of the casters pulled out and gave out. Boxes toppled over and fked up some slides.

Any where to get replacement drawer slides for an SPG international?

Or maybe better off to just replace the lower roller.....

 

[racingtadpole]

When my small roll cab caught my drill press after a random act of stupidity on my part I had to purchase OEM slides for it (its not an International though). Try getting a local tool store to get them in as a spare or contact the rep for you. Turned out in my case, they weren't overly expensive, they were however a PITA to fit.

 

[PhantomEB]

Will try that route. Was hoping there be an online source.

 

[My Old Tools]

O'Reilly's carries the boxes. Maybe they can get them.

 

[My Old Tools]

Customer Service - USA
Nancy Beliveau
[email protected]

Customer Service - USA
Nathalie Provencher
[email protected]

 

[PhantomEB]

I Canadian and when I asked even for the badges it was we don't deal direct so I got to go thru a retailer.

 

[MikeF2316]

I Canadian and when I asked even for the badges it was we don't deal direct so I got to go thru a retailer.

NAPA branded boxes in Canada are SPG International. They even use the same model names. They sell parts for them too.

 

[Burgerkong]

I Canadian and when I asked even for the badges it was we don't deal direct so I got to go thru a retailer.

Home Hardware, but IIRC warranty is only for 1 year through SPG - even for their SHD boxes go figure.

 

[Spdfreak91]

My SPG 56 takes these, This is where i got them http://www.ntxtools.com/network-tool-warehouse/SPG-3625C.html

 

[PhantomEB]

Thanks I will try a pair of those and go from there!

 

[1foxracing]

I Canadian and when I asked even for the badges it was we don't deal direct so I got to go thru a retailer.

That's funny SPG International also makes Wright Tool boxes, I e-mailed them asking if I could purchase the Wright Tool badges and they replied within 20 min asking for my shipping address so they could send them to me for free.