Drill Chuck Key I can't find one anywhere.

[Hephaestus29]

To fit this chuck. 5-20 MM J3

 

[warmpancakes]

I have a box of keys but no way to determine if one would fit. Is there a easy way to tell.

 

[Hephaestus29]

I don't know the way to tell but it's bigger than a half inch chuck. I guess I could measure the hole size & take pics of a half inch to compare. Wholesale tool doesn't carry them anymore so they put the chuck in the scrap bin. Thanks

 

[browntown]

I don't know how accurate this is, but according to this page:
http://punchout.buckandhickman.com/...+Machine+and+Power+Tool+Acc/product-is-228272

The key is a s4, which seem quite plentiful on UK websites, but I bet you can get one on ebay too.

 

[Hephaestus29]

Thanks I appreciate the info. I'll see if I can find one on ebay.

 

[marslawn]

Is that on a drill press? I have some brand new old stock Jacobs chucks

 

[Hephaestus29]

All I need is the key thanks. It was in a scrap bin at wholsale tool but it will go on my Smithy Lathe Mill Drill if I ever get a key for it.

 

[sc3013]

I just got a new Enco master catalog and wen't through it looking. I found nothing with those markings or that look. Also where in Indy is wholesale tool?

 

[rsanter]

find a place that has chuck keys in stock and find one by trial and error.
industrial tool and supply places as well as tool or motor repair shops

if there is a place that repairs DELTA or DEWALT nearby they generally have an assortment of chuck keys

bob

 

[mrpizza]

I have a ton of them. Measure the gap between the teeth and ill see if I have one to fit and ill mail it to you.

 

[Hephaestus29]

I just got a new Enco master catalog and wen't through it looking. I found nothing with those markings or that look. Also where in Indy is wholesale tool?

Wholesale tool is on Hanna Avenue just east of 31 about a half a mile North of 465 on the South side.

 

[Hephaestus29]

I have a ton of them. Measure the gap between the teeth and ill see if I have one to fit and ill mail it to you.

I'll measure it this weekend if not sooner i'm not in a rush to get it. I appreciate it though & i'm more than happy to pay for one. Thanks

 

[gmcref]

Just go buy one of each at a hardware store & test them without opening package. I did this last summer & the merchant gladly took back the ones I didn't need

 

[R. J. Sorensen]

Try McMaster-Carr; industrial supply house.

Have most everything.

R. J. Sorensen
[email protected]