Looking to get a vise grip type hold down clamp for the drill press. Most of the ones I see have a big nut on a loop, where access to underneath is required. My table has slots like a T, only hole is in center, directly under the drill bit. Any leads are welcome. Thanks.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Drill press clamp
- Thread starter SwampCat
- Start date
Would something like this work for you? They have a smaller mini version too.
https://www.rockler.com/hold-down-clamp-5-1-2l-x-1-1-8w
https://www.rockler.com/hold-down-clamp-5-1-2l-x-1-1-8w
thickhead
Well-known member
What did you buy?Better late than never. Finally found one. Dont know how I went this long without. Handiest clamp in the garage, fingers say thank you.