To avoid these ads, REGISTER NOW!

Dual Pane 3x2 windows?

mltdwn12

Active member
Joined
Feb 28, 2018
Messages
32
Location
Phoenix now, Berkeley Springs WV in June '18
I'm working on insulating my 32x50 pole barn before winter gets here in Berkeley Springs, WV. I've heard the single pane horizontal sliding windows will be a source of heat loss and I should change them out with dual pane models. I have not been able to find any 2x3 units, any suggestions?

Craig
 

Attachments

  • windows.jpg
    windows.jpg
    79.4 KB · Views: 41
To avoid these ads, REGISTER NOW!

kbs2244

Well-known member
Joined
Nov 11, 2006
Messages
14,065
I second the storm window idea

They can be installed inside if it is easier
 

The Cobbler

Super Moderator
Staff member
Joined
Oct 24, 2013
Messages
25,926
Location
Niagara Region, Ontario, Canada
even the best of windows are a great heat loss.
what you have there is maybe R-1
a thermal pane is maybe R-5 at best
calculate the square footage of windows vs the square footage of heat loss, it doesn't add up to much of an issue,
however, as others noted, add storms, or plastic for the cheap way out .
if you're heating constantly , look at better windows . or not
my $0.02
 
To avoid these ads, REGISTER NOW!

Milton Shaw

Well-known member
Joined
Feb 11, 2011
Messages
4,839
Each pane of glass is just an R1 so single is R1, double is R2, triple is R3. You add argon, coatings etc to any of those and they only go up less than 1 in R value. So max double pane is R2.5.. Calculate heat loss and unless heated 24/7 you are never going to lose enough heat to pay for the windows.
 
OP
M

mltdwn12

Active member
Joined
Feb 28, 2018
Messages
32
Location
Phoenix now, Berkeley Springs WV in June '18
Thanks for all of the replies, everything you all say makes sense given the size of the windows vs. the overall wall space. The other thing I was told is coming true, I was told I am building a work space not a living room. With temps in the high 40's and 50's lately, I get out there and continue working on the studs for insulation, I get warm and start peeling shirts off :) I really just need the main large space warm enough that the motors don't freeze, say 50-60 degrees and the smaller work space to be about 65 degrees for fiberglass work.
 
Last edited:

Walter_TA

Well-known member
Joined
Mar 11, 2017
Messages
191
Small world. I live in Berkeley Springs also. I live up by Hancock, how about you? What are you going to do in your new building? How are you going to heat it? Heat Pump works well. For the size of your building you may need two.
 

Falcon67

Well-known member
Joined
Jun 11, 2009
Messages
18,371
Location
Merkel, TX
I have 5 2x3 dual pane but they are vertical, not horizontal. 2 of the 5 have lost their counter weight springs, in spite of being fairly expensive units. Two of them really need to be 2x5, so I may be chopping into the wall in the future LOL.
 

kbs2244

Well-known member
Joined
Nov 11, 2006
Messages
14,065
Motors will not freeze until allowed to "cold soak" at below 30 degrees.
A cold soak at 30 degrees will take over 24 hours on a modern V6.
 
To avoid these ads, REGISTER NOW!
Top Bottom