Dunlap 1/3hp Motor Electrical

[WaltQ]

I recently picked up a Rockwell 32" radial drill press. It had a Dunlap 1/3HP split phase motor attached to it. Has anyone restored this type motor? I believe the model number might be 115.6960. The wiring is old and brittle and should be replaced. The motor runs quietly and smooth. Any suggestions on how far I should go on the wiring replacement.

 

[Roberts210]

Can you post a picture of the motor? That said, when I rebuilt old motors I always ran new wiring all the way into the leads, inside the motor. I also generously brushed Glyptol red over the windings.