I was given a Dynapak 4Xi plasma cutter since it was not working. Does anyone know about them? I have searched on the web and can not find much on repairing them.
I have done the basic checks; Replaced the switch. No broken wires between the handle and board. No blown fuses. Switch for the air coming in works. Grounds are good.
The machine fires up. But the DC light does not come on or start an arc for cutting.
I have bought a manual but there is not much in there about fixing it.
I have done the basic checks; Replaced the switch. No broken wires between the handle and board. No blown fuses. Switch for the air coming in works. Grounds are good.
The machine fires up. But the DC light does not come on or start an arc for cutting.
I have bought a manual but there is not much in there about fixing it.