Getting closer and closer to getting started on the electrical. Attached is my layout for all my electrical above 5ft from the floor. Accept for the 240s on the wall everything in the diagram is for high on the walls and lights. I am planning on a Miller 211 welder & using a Delta 50-760 vac on 220. Any and all comments for improvements would be GREAT!
Also I am a little confused on the wiring of light banks A & B. Any input on what would be the best way to wire those all up would be greatly appreciated (12/2 or 12/3 and how many breakers and layout) FYI I have a 200 amp panel in the front of the shop and a 100 amp sub panel in the rear of the shop (Figured it was cheaper to have the sub panel since that is where my compressor and two mini splits will be at.) My compressor is in it's own little room behind the shop. Thanks a lot.
http://pics.ct1.us/pics/Shop_Wiring.pdf
Also I am a little confused on the wiring of light banks A & B. Any input on what would be the best way to wire those all up would be greatly appreciated (12/2 or 12/3 and how many breakers and layout) FYI I have a 200 amp panel in the front of the shop and a 100 amp sub panel in the rear of the shop (Figured it was cheaper to have the sub panel since that is where my compressor and two mini splits will be at.) My compressor is in it's own little room behind the shop. Thanks a lot.
http://pics.ct1.us/pics/Shop_Wiring.pdf