Kevin C
Well-known member
I wanted a nice cover to go over the LB junction that matched the wall outlet.
View media item 48301
I bought a stainless steel push plate, thats used on doors and trimmed it down. Four screws later and its done. Total cost was about $10.
View media item 48302As long as I was getting carried away.... This is the access to the back side of the hose bib; its a stainless steel vent from a boat. It helps keep the end of the valve that on the inside of the wall a bit warmer.
View media item 48301
I bought a stainless steel push plate, thats used on doors and trimmed it down. Four screws later and its done. Total cost was about $10.
View media item 48302As long as I was getting carried away.... This is the access to the back side of the hose bib; its a stainless steel vent from a boat. It helps keep the end of the valve that on the inside of the wall a bit warmer.
