- Location
- CA
- Price
- 225
Selling a factory Craftsman multi-speed pulley attachment for vintage Craftsman drill presses.
I have overhauled this unit with brand new sealed bearings. It runs very smooth and tight and will give years of good service.
The factory part is a small cast iron base with a cast iron sleeve. This will fit up to 2.375" ID bores which the early full size drill presses had. The unit does not have the snap rings which adapt it to the bigger 2.475" bores but I will supply an aluminum shim to make it fit. This is the same shim that comes in my own customer slow speed pulley kits.
Asking $200 + shipping (probably $13 for USPS flat rate). Buyer covers PayPal fees.
Please PM me with any questions! Thanks
I have overhauled this unit with brand new sealed bearings. It runs very smooth and tight and will give years of good service.
The factory part is a small cast iron base with a cast iron sleeve. This will fit up to 2.375" ID bores which the early full size drill presses had. The unit does not have the snap rings which adapt it to the bigger 2.475" bores but I will supply an aluminum shim to make it fit. This is the same shim that comes in my own customer slow speed pulley kits.
Asking $200 + shipping (probably $13 for USPS flat rate). Buyer covers PayPal fees.
Please PM me with any questions! Thanks
Last edited: